Tureng Forum - Yalnız Mesajı Göster

**ALI-KARABULUT** · **31-03-2008, 11:17**

Perpendicularity — The condition of a surface or axis at a right angle to a datum plane or axis. Perpendicularity tolerance specifies one of the following: a zone defined by two planes perpendicular to a datum plane or axis, or a zone defined by two parallel planes perpendicular to the datum axis.

http://brownandsharpe.com/geometric-...nd-tolerancing

31-03-2008, 11:17	#3 (permalink)
ALI-KARABULUT Master Gaziantep Çevirmen Mesajlar: 2.823 Mesaj Onayı: 109 356 Mesajı 427 Onay Aldı	Perpendicularity — The condition of a surface or axis at a right angle to a datum plane or axis. Perpendicularity tolerance specifies one of the following: a zone defined by two planes perpendicular to a datum plane or axis, or a zone defined by two parallel planes perpendicular to the datum axis. http://brownandsharpe.com/geometric-...nd-tolerancing
Çevrimiçi